每次卸貨時,請使用油罐車將水槍移插槽,葉片,進水口,水箱,角落處,停止清潔并防止以后的混凝土沉淀物融化。清潔并不容易。如果您將超過1立方米的純凈水倒入水族箱,則在地面旋轉的水族箱體的洗滌將停止??梢栽诓僮鬟^程中隨時清洗,并且在分配器停止后可以徹 底清洗。
When unloading each time, please use the tanker to move the water gun to the slot, blade, water inlet, water tank and corner, stop cleaning and prevent the concrete sediment from melting. Cleaning is not easy. If you pour more than 1 cubic meter of pure water into the aquarium, the washing of the aquarium rotating on the ground will stop. It can be cleaned at any time during operation and thoroughly after the distributor stops.
多功能攪拌車的供水過程:控制氣壓并固定接頭。儲罐壓力為出廠設置。您不必自己進行調整。如果需要在特殊情況下進行調整,建議將氣壓控制在3.5mpa。
Water supply process of multifunctional mixer: control the air pressure and fix the joint. The tank pressure is factory set. You don't have to adjust yourself. If it needs to be adjusted under special circumstances, it is recommended to control the air pressure at 3.5Mpa.
由于原料不同,每個貨盤的具體質量會略有不同。裝載混凝土時,請仔細檢查坍落度和連接處,并注意混凝土的過早熔化和分層,以防止其被運送到現場。無法使用它,它破壞了勞動力和物質資源。請注意運輸距離。某些性能可能會改變。建議將此距離的直徑保持在30以內。
Due to different raw materials, the specific quality of each pallet will be slightly different. When loading concrete, please carefully check the slump and joints, and pay attention to the premature melting and delamination of concrete to prevent it from being transported to the site. It cannot be used, it destroys labor and material resources. Please pay attention to the transportation distance. Some properties may change. It is recommended that the diameter of this distance be kept within 30 km.
在離開車輛之前,規劃
多功能攪拌車的交通條件。然而,這僅增加了車輛在道路上的行駛時間。如果遇到無法排空的人造或吸引人的元素,請檢查儲水箱的狀況。一旦混凝土開始熔化,就應立即排干材料,以免損壞整個儲罐。
Before leaving the vehicle, plan the traffic conditions of the multi-function mixer. However, this only increases the travel time of the vehicle on the road. If you encounter artificial or attractive elements that cannot be emptied, check the condition of the water storage tank. Once the concrete begins to melt, drain the material immediately to avoid damaging the entire tank.